Return

Sabre Tech & Modifications

Street-Rod Cool Twin-Plug Three-Valve Cylinder Heads Five-Speed Constant-Mesh Transmission Offset-Dual-Pin-Crankshaft Shaft Final Drive

The kit DC Adaptor installation (cigarette lighter)

by Jay "HeyYou" Ginsbarg

The Kit

DC Adapter with rubber water resistant cap complete with inline fuse holder, extra wire & crimp terminals.

Tools needed
  • screwdriver
  • crimp tool
  • #12 & #10 socket
  • plastic or rubber tape
  • BLACK tie-wraps

I used “Fusion Tape” instead of electrical tape. Bonds the rubber together and makes it weather resistant.

I used a “loop” of wire and painted one end white (no red paint to mark the “positive”)

I wrapped the black and red wires into their own little harness & left about 6” slack in case I ever need it.

I ran the wire under the tank and as far as I could push it up there and then around the neck cover and clamped with a ty-wrap then wrapped with tape.

Finished.

Time for a smoke!

Editors note: The Sabre Group does not endorse or condone the use of tobacco products and is firmly behind the American Lung Associations Freedom from Smoking program.

Disclaimer: Any person who decides to perform any of the above listed modifications, does so at their own risk.
The Sabre Group does not claim any responsibility for damage to your motorcycle or individual.